3D models have been updated

Some sight changes were made to modules. The edges of the modules were chamfered. This gives a better feel and helps preventing “elephant foot” when printing with a nozzle being too low. Positive and negative markings were added near terminals.

Powerwall

I have been thinking of the way i could adapt my design to be used in DIY powerwall for some time. As it was too expensive to use hardware making NESE modules left me with some 2P tabs which could … Read More

8P module

Printed 8P prototype to expand the range. It bumps up the capacity to almost 30AH range. Bellow it is in comparison to 6P module, about the size of LG V20 smartphone. What you think, good, too much?  

power bank

Started deriving my N.E.S.E enclosure to make a power bank. 3P, 4P modules will have leftovers after cutting tabs to size. There will be enclosure available to print and fit power bank electronics and have 2.1A and 1A outputs to … Read More

the future people

Cameron and Rachael Vandyke. These are the guys i am following for some time. Really different approach to velomobiles and things they do. This is how cars could be replaced in urban areas. I was told by Cameron that new … Read More

rebellious in a way

I would like to post some sites about people, that stand out, that i feel are interesting. Here is a first post. Peter Rumjantzeff. Here is the article: Rebellious in a way. All photograph are courtesy of http://helsinkiheroes.com